pro engineering tutorial part6

continue with the tutorial yesterday

Component placement panel will appear at the bottom, we will choose

Automatic reference constraining based on which we will specify, as

We choose the reference axis A_2 to Crank (arrow 1) and back A_3 Conrod

(Arrow 2), as shown below

The second restriction will be made from parts of Crank, the first constraint is the

Crank shaft into the hole into Conrod, the second constraint is the

Conrod paste, click on the side of Conrod like the picture below.

We turn in the Orient click icon mode on / off> then take a pointer

with their> press the middle mouse button> swivel parts as shown below,

Tap the icon Orient Mode on / off button again to exit

click on the left side of the part in Crank (arrow 1), enter the offset value of 0

mm (arrow 2)> click the check mark to continue with the next step

Results of constraint first

continued

pro engineering tutorial part5

continue with the tutorial yesterday

We will move into the piston Conrod> Soft Panel click (arrow 1)> select

Offer Type = Translate (arrow 2)> click on the Conrod his left> drag to the right, for example

picture

The second restriction will be made from Conrod of the first constraint is the

into the pin hole on the piston, the second constraint to the distance 62

mm from outside the engine block on the Conrod, we turn the point of view by clicking on the icon

Orient Mode on / off> then take a pointer to their> press the middle mouse button

> Turn the part as shown below, the Orient Mode icon press on / off again

to retirement.

Click the Placement Panel (arrow 1)> New Set click to send restricted in two (arrows

2)> click on the first reference to the outside of the engine block (arrow 3)> for reference

The second click on the outside of the Conrod (arrow 4)> select Offset (arrow 5)> enter the distance

offset 62 mm (arrow 6)> then click the check mark next to

We will be the last part (Crank) into the assembly system, starting with

click on the "Enter the assembly component" in the toolbar right-> dialog

We will see Open> select crank.prt> then click Open

continued

pro engineering tutorial part4

continue with the tutorial yesterday

We will move to the top> click Move panel (arrow 1)> Motion Type select =

Translate (arrow 2)> click on the piston portion left> draw up, as shown

In order to simplify the display, turn the Datum Planes; points Datum & Coordinate

System (arrow 1)> Go back to the Panel> Motion Type select Rotate (arrow 2)>

rotary piston about 90 degrees (arrow 3), it looked like this, and then click on the

check to continue with the next step.

We will add a third (Conrod) into the assembly system, starting with

click on the "Enter the assembly component" in the toolbar right-> dialog

We will see Open> select conrod.prt> then click Open

Component placement panel will appear at the bottom, we will choose

Automatic reference constraining based on which we will specify, as

choose the reference axis and the axis of Conrod A_4 A_5 of the piston, such as

figure below.

continued